Both new TS fairway models feature similar technologies as the drivers including extremely thin crowns that are 27% thinner for lower and deeper CG locations thinner clubfaces with variable thickness for more ball speed distance and forgiveness on off center hits and better weight distribution for higher MOI and stability.
The Z 785 driver is revolutionary for Srixon for a number of reasons but mostly because it produces up to 3 mph more ball speed than the previous model yielding up to ten more yards of total distance. The key to the impressive improvement is a new Ti51AF Cup Face which is lighter and significantly stronger allowing it to be made 10% thinner for more COR and ball speed at impact.
None of the above matters if you can’t aim your putter correctly Experiment with offset and straight-in hosels — you’ll definitely aim one type better than the other. Then check the alignment marks. Do you prefer lines that run parallel to the target? How many lines? These are important questions that can best be answered through a proper fitting.
Featuring a blade-like clubhead with a small cavity and relatively narrow sole the Z 785 has more mass behind the sweetspot for improved versatility as well as a new Tour V.T. sole that improves turf interaction.
Matching putter type to stroke shape isn’t a great fitting strategy. In fact research indicates that how you “release” the putter is much more critical. Bottom line: If the putterface is square to the target line at impact it doesn’t matter what it does during the rest of the stroke. Selecting the correct hosel can make all the difference here.
Featuring the same Ti51AF Cup Face and lightweight carbon crown as the Z 785 the friendlier model comes standard with a Project X HARDUS Red shaft with an active tip section for higher trajectory shots for a wider variety of players.
A “stability frame” design strengthens the toe and topline while optimizing perimeter weighting for improved performance on mis-hits while a more neutral CG location that’s closer to the center of the face improves performance on center strikes.
Check them out and see if one is right for you but keep in mind the TS2 is aimed at those who want high launch low spin distance and forgiveness while the TS3 is aimed at those who want mid launch low spin and enhanced workability.
A slight draw bias is created by a removable weight located toward the heel of the clubhead that can also be used for swing weight customization but the Z 585 does not allow for loft lie or face angle adjustment.
A versatile iron that can fit a wide variety of players from pros to better weekend warriors the 919 Forged fits snugly between the Tour and Hot Metal models. Built with the same Grain Flow Forged HD method as the Tour the Forged is made from Boron infused steel which is approximately 30% stronger than carbon steel.
Optics are critical to putting success — if a putter doesn’t allow you to stand comfortably at address with your eyes in a position to consistently see the target line clearly it’s not for you. Look for a model than sets your eyes either over the ball or slightly inside of it so you can see where you want it to go.
As a result the TS2 and TS3 drivers represent a whole new level of speed and distance for the company’s big sticks. In addition are TS2 and TS3 fairway woods which benefit from the “speed project” almost as much as the drivers.